Ultrasonic Flowmeter / Calorimeter TFM2100-NG
- Non-contact measurement with sensors clamped outside the pipe
- Flow measurement in pipes DN15…DN6000
- 4-20 mA, Pulse, Relay outputs and MODBUS communication
- Can be used as a calorimeter with Pt-100 inputs
Ultrasonic Flowmeter / Calorimeter TFM2100-NG
It is mounted on the outer surface of all types of pipes that can transmit ultrasonic sound to measure the flow rate of clean liquids that do not contain air bubbles, such as chemicals, oils, water, wastewater. Installation of clamp sensors is done without stopping the flow. Thus, the air pressure reduced and no clogging occurs. It saves labor and time.
The measurement system consists of a pair of ultrasonic sensors acoustically coupled from outside the pipe. The server unit has a microprocessor, analyzes the signals sent and received from the sensors, and sends the signal to the control and process systems through an interface.
Application Areas:
- Application Areas:
- Water & Wastewater
- Drinking Water
- River Water
- Coolant
- Demineralized Water
- Crude Oil
- Mineral Oil
- Hydroelectric, Fire Extinguishing Stations
- Food, Beverage Industry
- Flow Balancing
- Glycol solution
- Hydraulic Oil
- Diesel & Fuel Oil
- Chemicals
- Petrochemicals
- Heating and Cooling Systems
- Fire suppression systems
Sensor Mounting Methods: TFM2100-NG sensors can be mounted on vertical (Upstream) or horizontal pipes. The pipe must be full. The choice of one of the V, Z, W mounting types depends on the application and pipe diameter. “V” Although the type is the most common, “Z” “W” mounting is suitable for large diameter pipes or weak signal applications. It is used in small diameter pipes.
- Wastewater and Drinking Water treatment improvement, muddy water and process water pumping
- Fuel and chemical industries
- Hydro-electric, cooling, fire extinguishing stations
- Separation industries
- Food, Paper and Pharmaceutical industries
- Automobile Industries
- Flow balancing
- Flow flow measurement for use in heat calculation in central systems
General Features
- Operation: For clean liquids containing less than 1% solid particles and gas bubbles in fully filled pipes
- Configuration: With built-in keypad
Transmitter
- Display: LCD backlit.(Total flow/Heat, Instantaneous Flow/Heat, Speed, Time)
- Sensitivity: %± Better than 1, Linearity: %± 0.5, Stability: % ± 0.2
- Supply: 220 VAC and 24 VDC
- Çoutput: 4-20 mA, Pulse, Relay
- Communication: Via RS485, MODBUS, M-BUS
- Operating Temperature:-20...50°C
- Protection: IP 65
Sensors
- Pipe diameter: For pipes with diameter DN 15...6000 mm
- Pipe Materials: All kinds of pipe materials made of metal or plastic material that can transmit ultrasonic sound (carbon steel, stainless steel, cast iron, dactyl iron, PVC, PVDF, fiberglass, copper, brass). ;, aluminum...) and interior coated pipes (epoxy, rubber, teflon, asbestos…)
- ÇOperating Temperature: Standard Sensors; -30…+90°C (TL-1,TM-1,TS-2) High temperature sensors; -30…+160°C (HTM-1, HTS-1)
- Sensor Mounting Kit: Includes stainless steel mounting clamps and acoustic bonding gel.
- Sensor Cable: Standard 6 m
Options
- Datalogger (with 2GB SD card)
- Resistance Thermometer (Pt-100) for calorimeter use
- Different cable lengths depending on need